I had previously purchased a current sensor from Sparkfun that was described in the Wiki for use with APM 2.0 boards. My question is, can I still use this with the APM 2.5 board and wire it up the same as the 2.0 in the Wiki?
You need to be a member of diydrones to add comments!
Replies
Im also wondering if there is a way with the new power supply/sensor that comes with the 2.5 board now, if you can have it NOT power the APM board and just read the battery consumption. I want to use the two battery setup, one dedicated for motor and the other for electronics, or should I just wire the video sepearate and keep all the electronics on the motor battery?