APM not working after crash

My tinycopter based on ardupirates stable code had a crash today. After that, APM/IMU is not working ok.When I connect the battery, the IMU leds starts blinking normally but after that... there is no green light showing that initialization was ok. No response to radio commands. Nothing!I can switch to CLI mode and then, I can connect via Serial Monitor and interact with cli menus normally. But if I change the switch to Non-Cli mode, then no solid green led and impossible to connect from configurator.Any ideas?Thanks in advance!

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • check the 6 pin connector next to the telemetry port
This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile
Jun 30
Santiago Perez liked Santiago Perez's profile
Jun 21
More…