Discussions

AR8000 not powering on from APM Arducopter 3dr

Posted by jonny bankz on March 19, 2012 at 7:55pm

Hi,I am working on my first Arducopter 3DR. I am through the build and have reached a block. I am not receiving any power lights on my AR8000 receiver. I have the lipo connected and what I believe to be the right pin out on from the APM to the AR8000. I am attaching a picture that shows all of the channels disconnected on the receiver leaving only the power from the APM to the AR8000. No lights when the copter powers on from the battery being plugged in. Any help will be greatly appreciated. I have yet to successfully bind the receiver to the transmitter. Thanks.

IMG_4576.JPG

You need to be a member of diydrones to add comments!

Join diydrones

ar8000, arducopter, receiver

Email me when people reply –

Follow

Replies

Ben M March 19, 2012 at 8:05pm

That is the bind port you must provide power through any of the other pins. It will get power when you attach the cable to the throttle for example. The first port is only for binding to your transmitter and telemetry.

1
2

of 2

This reply was deleted.

Activity

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.