"well issue that i had was that i had to reverse my yaw so it woried as specified. but first try to arm the escs by moving the right stick down and to the left and if that works you need to reverse the yaw. and hav eyou clibrated the escs?"

"Well when you attempted to spin your motors was the apm armed. Because when I attempted it for my first time I couldn't get them to spin either. But the while plugged into usb I realized they weren't arming and it was because I had to reverse the…"

"well it seems everything is conected right. so the only thing i can think of is that your not connected. make sure that your transmitter is on before you power the board."

"From your picture it looks like you have placed the power cable on the bottom two pins. It needs to be on the top two pins. The order is negative, then positive, then signal. From the top to the bottom."

"That is the bind port you must provide power through any of the other pins. It will get power when you attach the cable to the throttle for example. The first port is only for binding to your transmitter and telemetry."