Discussions

Ardu plane - flaps need help

Posted by nubli hashim on February 9, 2012 at 12:17am

it's been month since I last visited the forum.. I'm planning on using APM version 1.4 on board of EPO glider 1.6meter wing. the APM was used for y6 before. I'm currently using flaperon mix and comfortable with it for spot landing. right aileron on channel 1 and left aileron on channel 6

can anybody tell me how connect the servos to APM if I continue to use flaperon? as of now ,out pin: 1=right aileron servo, 2=elevator servo, 3=esc/motor, 4=rudder servo. where do I put the left aileron servo?

thanks guys

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

Phil Cole February 10, 2012 at 9:59pm

Two minutes of searching reveals

http://www.diydrones.com/profiles/blog/show?id=705844%3ABlogPost%3A...

and

http://www.diydrones.com/forum/topics/two-channels-aileron-control?...
james sowell February 10, 2012 at 12:26am

I whould plug the servo wire that works in to the one the one that is not working if it works its the y cable if it still wont work its the servo not a expert but hope it helps
james sowell February 9, 2012 at 4:04am

you use a Y cable

This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile

Santiago Perez liked Santiago Perez's profile

More…

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.