hi there, I just traying reset my apm board and I have CLI conecting bur in fly mode is no conecting
I reload de firmware, reset de apm no results, any help?
You need to be a member of diydrones to add comments!
This reply was deleted.
hi there, I just traying reset my apm board and I have CLI conecting bur in fly mode is no conecting
I reload de firmware, reset de apm no results, any help?
You need to be a member of diydrones to add comments!
Replies
Have you tried to reload the APM code? Reset button on oilpan/IMU may also help.
These suggestions are from the Arducopter troubleshooting guide in the manual.
regards, brett