Hi
I am building new copter based on pixhawk 2.1 and here+ gps. It will be quite big octo but for now it’s quad with 15" propellers. I have mission planner 1.3.52 and copter firmware 3.5.5. When I am connected to mission planner from time to time I get message “bed gyro health”. It happening almost every time when copter is just laying on the desk and nothing is happening with it. I did accel, level calibration and compass calibration. This info showing only for 1-2 seconds and disappears. I had one test fly and copter was quite steady. I don’t know where to search in log for problems with gyro which parameters I should observe ? For example gyrosq1 is 5 gyrosq3 is 5 but gyrosq2 sometimes is 50. I am quite worried that it’s hardware issue ? How can I check that ? I flashed firmware and did whole procedure of new settings two times and problem still exist :( Anyone any idea what is wrong ?
Please look at video:
It's strange for me that there is no any information with error messages from Mission Planner.
Can anyone help new member of arducopter community :)
Replies
It looks like that's not important message and it's safe to fly if it's not appearing during flight.
https://discuss.ardupilot.org/t/bad-gyro-health-in-new-copter-with-...