Discussions

BEC for servos

Posted by Mukil Babu K on February 19, 2016 at 9:48pm

I need to power 4.8V servos(used for deflecting control surfaces, not for motor propeller) from Pixhawk autopilot. I need to know whether its necessary to use BEC for those servos? If its necessary, can someone please explain where i need to connect the BEC. Is it between the power supply connecting autopilot and servos? A schematic diagram would be appreciable .

Thank you in advance

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

Francisco K March 1, 2016 at 10:26pm

Please have a read through this wiki, it will answer your question.

http://copter.ardupilot.com/wiki/common-servo/

This reply was deleted.

Activity

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.