Brushless motors stop at full throttle

Hello guys!! I am new here! I built a Hexacopter using arduino nano! during my tests, I noticed that at full throttle the motors stopped!! But, I used the apm 2.6 they worked fine with some delays in the response!! Then, I went to my initial arduino nano board to fly the hexacopter using my code , the motors worked fine without propellers but when I installed the propellers I faced the same problem (the motors stopped at full throttle). So, I tried to re-calibrate the ESCs using a R/C transmitter but I faced a problem where only some ESCs were calibrated and the other motors didn't spin!! after some trials I fried a brushless motor!! 

Please help!! waiting for your reply guys!!! thank you so much!!!

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • I have some tips:
    Clean up your crossposting , spamming 5 places does not help.
This reply was deleted.

Activity