Burnt Ardupilot 2.5.2
Hi Folks,
Today I made a bad connection in my hexacopter and I fried the Ardupilot 2.5.2 board. Still trying to figure out what I did because I'm just powering thru the 3DR power module.
A,C & Alive leds are coming up when powered from USB by no communication with the uController. Do you know where can I find the schematics for the 2.5.2 board? I believe what's burnt is a regulator (3v3 powering the uC?). Any ideas?
Thanks
Jose
Replies to This Discussion
-
Permalink Reply by Jose Olcese on -
Thanks a lot!.
Yes, it seems that's the burnt regulator. Will try to fix it and let you know. (and try to understand what happened :) )
-
Permalink Reply by Jose Olcese on
-
Well, it seems that something more than the regulator if burnt. I changes it and still not booting...
Where's the source code for the ATMEGA32U2? Will try to connect tru an external programmer.
-
Permalink Reply by Søren Kuula on -
its in the git repository (github.com/diydrones/ardupilot) Tools/ArduPPM
PS check fuse ( the one on the board, not the fuse bits :) ) and diodes. Are the 5 and 3 V supply voltages present?
Regards, Søren
Top Discussions
Groups
-
PIXHAWK
1109 members
-
Tower (Droidplanner)
155 members
-
X-UAV Talon
162 members
-
Micro Drone
43 members
-
ESPrtk -High quality RTK…
6 members
© 2019 Created by Chris Anderson.
Powered by
