I re post my question here hoping someone will lend me a hand.

I am running APM 2.73 with RDF900 with default radio setting. I can not send any command from flight data tab, eg : change altitude, change mode ect... Each time I try a error massage come out ( error change altitude...)

The strange things is I have another plane with completely same equipment and firmware, run with the same notebook but it was fine. I can do everything via GCS.

Please let me know where should I check or any setting to adjust. Thanks

Views: 216

Reply to This

Replies to This Discussion

Are you using apm planner? Can you download the parameters?

Reply to Discussion



Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service