This is my second set of APM+oilpan. I cannot connect to the configurator even though the baud rate and com port is correct.
I was able to read the flight data before but i cannot even connect to the configurator now.
What i have done: I have reset the EEPROM and reload the Alpha_rc1 code. But still cannot connect to the configurator.
Could the APM faulty again? The A led is in solid green and the TX led keep blinking.
Replies
Have you set the timeout to 30 seconds?
If so, try installing the Configurator on another computer (maybe the LabVIEW driver is corrupted).
Or, better yet, load RC2, which has a built-in Command Line and doesn't need the Configurator.