I need to slow down the serial output from my ardupilot board because my xbees only transmit at 9600 baud. (XSC's)
Where is that setting and how can I change it?
You need to be a member of diydrones to add comments!
This reply was deleted.
I need to slow down the serial output from my ardupilot board because my xbees only transmit at 9600 baud. (XSC's)
Where is that setting and how can I change it?
You need to be a member of diydrones to add comments!
Replies
Ive already changed the "define SERIAL3_BAUD 9600" setting
I want to change the output rate of the serial data coming from the imu. So the stream of charicters from the board is less frequesnt.
I'm not referring to the 9600 baud rate.
Where is that setting?
i think you will find xsc's to slow,and wont work properly
It's in the manual.