About

About Me:

na


Please tell us a bit about your UAV interest

na


Activity Feed

dylan posted a discussion
Looking for the wiki page for the ServoSwitch V10.Does anyone know of a good guide?
Mar 1, 2012
dylan commented on Ramon Natal's blog post New Lithium Titanate Batteries the perfection of Li-po
"I have researched this technology a lot. LiTi is not as good as LiPo for rc aircraft because it has a lower energy density. But when you factor in the long life, reliability, carge rate and max current output; LiTi looks to be the next step.

That…"
Feb 20, 2012
dylan posted a discussion
Do the xbee XTend 1 Watt modules work for telemity in place of the 900 pro's?What telemetry gear is the apm2 hardware (purple board) going to use?Is an RC receiver / transmitter required or could all control be sent over xbee modules?When telemetry…
Feb 19, 2012
dylan posted discussions
Dec 25, 2011
dylan replied to dylan's discussion Downgrade firmware
"Also why is there not a feature to pick or load a firmware package in Mission planner???"
Dec 25, 2011
dylan replied to Kevin's discussion ArduPlane v2.27 alpha
"Trying 2.27 out. Everything nut the relay is working for me...

How do i get 2.26 back?"
Dec 25, 2011
dylan posted discussions
Dec 16, 2011
dylan replied to dylan's discussion Change serial data rate
"Ive already changed the "define SERIAL3_BAUD   9600" setting

I want to change the output rate of the serial data coming from the imu. So the stream of charicters from the board is less frequesnt.

I'm not referring to the 9600 baud rate.

Where is…"
Dec 16, 2011
dylan replied to Doug Mac's discussion XBEE 900XSC
"I have the same units and the data rate limit is 9600. This is too low for the arduPliot and the serial data piles up and it crashes the link. Im working on lowering the output of the AP so I can use these xbees.

Let us know if you had any luck."
Dec 16, 2011
dylan replied to Tommy's discussion Upload/Dowload to ArduPilot
"ok I got it to connect but after about 1 min I get this error

"B|::?'dB:6j2}lost 11 pkts 231bps 923 loss 11 left 7 mem 38519992Mavlink Bad Packet (crc fail) len 40 crc 63739 pkno 30:"[p%lost 59 pkts 234bps 922 loss 12 left 1 mem 38618296REQ streams…"
Dec 10, 2011
dylan replied to Tommy's discussion Upload/Dowload to ArduPilot
"I Want to change baud line #define SERIAL3_BAUD        9600

Once the APM_confih.h file is edited how do I get it loaded???

Is there a guide I'm missing?"
Dec 10, 2011
dylan replied to Stephen Rayleigh's discussion Xbee xsc 900
"Is there a guide on how to change the baud rate in the APM_config.h file and get it uploaded?

Ive change the file with notepad but not how is it uploaded?"
Dec 10, 2011
dylan replied to Stephen Rayleigh's discussion Xbee xsc 900
"Yeah I have the same question!
I can get my XSC's to talk to each other from one laptop to another but no go once I connect it to the ardupilot hardware. "
Dec 10, 2011