Discussions

Replies

  • Stuart Brookes March 23, 2015 at 1:37pm

    did you click refresh?

    • Peter Everett > Stuart Brookes March 23, 2015 at 1:58pm
      Yup, it shows channel 6 moving up down, I even recalibrated just be sure..
      • Stuart Brookes > Peter Everett March 23, 2015 at 2:09pm

        hmmm ok not sure whats up then, your tune param looks correct and matches as seen on your screen shot. If you look at the full parameter list and refresh does the rate roll/pitch kp param update there? can you see chan 6 chaning in RCin in your log file?

        • Peter Everett > Stuart Brookes March 23, 2015 at 4:18pm

          Ok, it was me being stupid.. I just refreshed the extended tuning page and the values do change. It's take a few seconds, I think I didn't wait that long before, sorry.

          Thanks for your help Stuart.

          • Stuart Brookes > Peter Everett March 24, 2015 at 1:52pm

            Cool :), yeah it takes a little while

        • Peter Everett > Stuart Brookes March 23, 2015 at 4:15pm

          Hi Stuart,

          If I go to the status window in flight data ch6in changes value as the knob is turned although none of the chXout values change. RATE_RLL_P does change does change if I move the knob and refresh the params.. Weird..

          Capture.JPG

          https://storage.ning.com/topology/rest/1.0/file/get/3702781207?profile=original
    • Peter Everett > Stuart Brookes March 23, 2015 at 1:50pm

      I did Stuart, well I clicked write params first then refresh too.. Does the Mini support channel 6 tuning I wonder..?

      • Stuart Brookes > Peter Everett March 23, 2015 at 1:51pm

        Should do, is channel 6 updating on the rc calibration page?

This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile
Jun 30
Santiago Perez liked Santiago Perez's profile
Jun 21
More…