Hey guys,
I have this UBEC and the Arduflyer. The connector on UBEC is 2-pinned, but the PWR connector on ArduFlyer is 6-pinned. Can someone elaborate how this is supposed to be put together? :)
Hey guys,
I have this UBEC and the Arduflyer. The connector on UBEC is 2-pinned, but the PWR connector on ArduFlyer is 6-pinned. Can someone elaborate how this is supposed to be put together? :)
You need to be a member of diydrones to add comments!
Replies
you power it by connecting the two pinned connector to the output rails (ch 1-8) and putting a jumper over the two pins just above there. (JP1)
Make sure you get the polarity right of the ubec connector