About

Gender

Male


Location

Celje


Please tell us a bit about your UAV interest

I am interested in everything that flies. I particularly like to work with sensors, giving drones the feel of the world around them.


Activity Feed

Primož Kralj posted a discussion
I'm having a bit of a problem with my quadcopter controlled by APM3.2; sometimes motors stop spinning mid-air and quad drops dead on the ground.I'm trying to find the cause but have curiously found out that no logs are present. I've dug deeper and…
Jun 26, 2015
Primož Kralj replied to Primož Kralj's discussion Can't get Turnigy 9X working
"Hey Ian, the problem in my case was bad connection between the module and the pins: http://openrcforums.com/forum/viewtopic.php?f=5&t=3622&mobi...

"João, that was the problem! The board inside the module was not properly mounted causing a bad…"
Aug 8, 2014
Primož Kralj posted a discussion
The thing is I crashed the other day and the battery with leads was torn off the back of the GPS. The result is that now I have to wait a few minutes for GPS fix. If someone could kindly share how the battery was mounted on originally I would be…
Aug 17, 2013
Primož Kralj commented on OneDrone.com's blog post DronExpo 2013
"Wow, lucky to saw this today as it takes place tomorrow :) I hope I will be able to test some FPV equipment as I am looking to buy it."
Aug 14, 2013
Primož Kralj posted a discussion
I've bought propellers from RCTimer (http://www.rctimer.com/product_638.html). There are 12 pairs of CW and CCW propellers. On half of them there is an adittional label "R". Does this stand for "reversed" (CCW)? I couldn't find an answer anywhere…
Jul 27, 2013
Primož Kralj replied to Marcel H's discussion APM 2.5 radio calibration dont works.
"I'm having the same problem. Tried calibrating using CLI with no success. Testing in CLI also gives no response. I have other sensor readings though.

Did you fix this problem?"
Jun 14, 2013
Primož Kralj commented on Kevin Hester's blog post Please do three small things to help create drones.stackexchange.com
"I was thinking just the other day why isn't there a drones QA at stackexchange :) Will support."
May 29, 2013
Primož Kralj posted a discussion
Hey guys, I'd like not only to power the LEDs using LiPo but also make them blink. I though I need to connect them to APM's output rails and program APM for them to blink. Stripes are these from HobbyKing.Is this possible and if yes does anyone have…
May 17, 2013
Primož Kralj replied to harin sanghirun's discussion Radio Calibration Problem Turnigy 9X
"Hello, di you solve this problem? I am having the same."
May 12, 2013
Primož Kralj posted a discussion
**NEW FINDINGS**:I disconnected every cable from receiver and hooked up a servo (and power of course) to check if I get any response. Turns out I can't even move servo using Rx/Tx! I can hear servos when they are first plugged in though.If I turn…
May 12, 2013
Primož Kralj posted a discussion
Hey guys, I have this UBEC and the Arduflyer. The connector on UBEC is 2-pinned, but the PWR connector on ArduFlyer is 6-pinned. Can someone elaborate how this is supposed to be put together? :) 
May 10, 2013