About

Gender

Male


Please tell us a bit about your UAV interest

quadropter are just awesome


Hometown:

Bangkok


Activity Feed

harin sanghirun replied to harin sanghirun's discussion How to clean the 850Kv Jdrone Motors?
"OK, never mind, I found the solution. Just remove the C-clip on the bottom of the motor and pull the top with the shaft out."
Mar 13, 2013
harin sanghirun posted a discussion
I crash my quad-copter into a muddy area and some mud have gotten into the motor. Is it possible to open up the motor and get the mud out? Thanks
Mar 12, 2013
harin sanghirun posted a discussion
The quad won't change to any other mode other than stabilize and Alt Hold.I have my flight mode set up like thisMode 1 - LandMode 2 - StabilizeMode 3 - StabilizeMode 4 - LoiterMode 5 - Alt HoldMode 6 - StabilizeWhen I turn my quad on it will be on…
Aug 27, 2012
harin sanghirun commented on Gordon's blog post Mode Switch Setup for Turnigy 9x
"I finally got mine to switch in order, what I had to do was swap the pulse in the guide of the position N and position 1. "
Aug 27, 2012
harin sanghirun commented on Gordon's blog post Mode Switch Setup for Turnigy 9x
"Thanks a lot Gordon! There is no way in hell that I will be able to figure this out!
One question though, the pwn seems to be jumping (1682 to1819 to 1555)around when switching from N to1 to 2. Is this the tx limitation which does not allow pwm…"
Aug 26, 2012
harin sanghirun posted a discussion
I was recently given Turnigy voltage detector, but was unsure about how to install it on the apm1 board. I checked the wiki, which has a instruction for the AttoPilot sensor, which has 3 wires, while this one only have 2 (red and black).Do I just…
Aug 12, 2012
harin sanghirun posted a discussion
The signal range on the ch.2 (pitch) of my turnigy 9x was dramatically reduce from about 1000-1800 to 1600-1800. While other channels remain at about 1000-1800. Does anybody know what could possibly cause this?Notes. Yesterday I opened up the tx to…
Aug 6, 2012
harin sanghirun replied to harin sanghirun's discussion Radio Calibration Problem Turnigy 9X
"This is what I got when I tried to calibrate the radio in the first time setup. The APM doesn't seem to get any signal from the rx. However, when I connect the esc directly to the rx, they all work (motor spins), but ch5-6 is not controllable by the…"
Jul 23, 2012
harin sanghirun replied to harin sanghirun's discussion Radio Calibration Problem Turnigy 9X
"Rx to APM 1 connections"
Jul 23, 2012
harin sanghirun posted a discussion
First of all I have to say that I'm completely new to the RC world.Today I just finish assembling an quadcopter kit from jDrones. I loaded the latest firmware onto the APM 1 and everything seems to be working fine, but when I try to setup for the…
Jul 23, 2012