Control surfaces for Pixracer


If this is the wrong place to put this please redirect me to the proper board. My issue is trying to configure the control surfaces from the pixracer to the mission planner software (Qgroundcontrol). The servos are being hooked up to channels 1 and 2 but I am not sure on how to make the servos communicate with the software. Any help would be appreciated, thank you! 

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –


  • Hi, did you resolve this issue? I'm having similar difficulties with my servos and ESC doing nothing.
This reply was deleted.