et al
I have a tricopter 3 motor version. All was running well and I was learned how to fly it pretty well. Then i upgraded Firmware to V3.2.1 I had all kinds of problems. I finally have everything down through calibration.
What happens now is I can finish Radio calibration but when I go to Arm Down and to the Right the lights flash like it is going to arm but the Mission Planner gives me a warning FAILSAFE NO RC RADIO.
How is this, it sees the radio during calibration?
Anyone have ideas on how to get this going/
Thanks
Bryan
Replies
Hello Bryan,
J have same problem, have you found an issue.
best regards
Patrick
Have you figured this out, by any chance? I'm having the same issue