Frame is modded from open frame, hobby king frame, etc and lot of own time. Any way it works. Many people says that arducopter Y6 Software is bad. I disagree that.
https://www.youtube.com/watch?v=sw6kOBu_Syk
https://www.youtube.com/watch?v=3e4r_N8P2bY
-Tema
Replies
Only problem is if i fly outside in stabilize mode and make a lot of corrections and especially if drive fast, copter suddenly take a some direction to fly and i have to take full back, right, left, front or something to take that bird back close to me.
Do we have a broblem whith wibes or what. Normally if i fly inside there is no that kind of problem, cause of a smaller movements and no wind correction. I never use gps.
I have been flip copter few times in same kind of situation.
And it is a same kind of problem with x4 and y6.
Ardu board is isolated with soft foam and all the propeller are stabilized.
I think there is no electricity problem also. (4s 35c lipo) Cables and stuff ok.
No servos to take extra power from esc (30a jdrones esc)
I allready thank you all! =)
-Tema