In Mission Planner, Initial Setup.Install Firmware V3.1 5 Quad . After do you want to upload Ardu Copter V3.1.5? Each time I connect the page goes to download, the screen freezes, when I remove the plug from the quad, the table immediately goes to downloading and the bar starts across the bar and then the attached table comes up saying that Com8 does not exist.
If I go into Wizard and go through the Initial Setups after changing to 56700 and accessing the correct port, it all works except on the last page where it shows that the Autopilot is not activated.
Can somebody help with this issue.mission%20fail.jpg
Replies
DO NOT DOWNLOAD AUTOPILOT FIRMWARE ONTO YOUR WALKERA QR-X350 PRO!!!!!
That's not good! I recommend downloading the official firmware, and flash tool from the Walkera website. And reflash the latest firmware.
-
1
-
2
of 2 Next