Wow I feel like a fool and I almost don't want to post, but I have been working on this for awhile and I know its something silly. I am trying to set up elevons on a Stryker. I have tried the dipswitch method as well as configuring via the APM Mission PLanner/Mavlink(my preferred method). I am using a JR 10X Heli (reset model), but this shouldn't even matter for question 1, correct?1) When going into Stabilize mode, I can only get the pitch or roll to move in the correct direction. When one is working, the other is reversed. I have several combinations of settings. Right now, my settings are:ELEVON_CH1_REV 0ELEVON_CH2_REV 0ELEVON_MIXING 9The APM is correcting pitch in the correct direction, but not roll.2) Manual mode R/C control works fine. When switching to stabilization mode, the elevator channel controls ailerons and aileron channel controls elevator. I have seen other people post this and they said when starting from scratch on the model config, this resolved it. I have done this to no effect.Please tell me what I must be missing in the manual or other forums???
You need to be a member of diydrones to add comments!
Austin,
Did it all work after you got the manual transmitter working? I'm having similar problems. I THINK I've followed the instructions to the letter. I'm going through it again right now.
Replies
Did it all work after you got the manual transmitter working? I'm having similar problems. I THINK I've followed the instructions to the letter. I'm going through it again right now.
I'm afraid I'm not following. Re: #2, it sounds like you've got your connectors reversed.
As for #1, it's just a matter of getting the combo right.