Hello, I have an APM plate 1280 and until now never had problems loading the software on my plate from APM Planner, but today I updated to v2.251 arduplane and it gives me error checking.
(upload succeeded, But verify failed: exp 10 got C at 126 976)
I must say that even before the v2.251 version I had worked properly, both the burden ofsoftware as the general functioning of the APM.
You need to be a member of diydrones to add comments!
Replies
There is needed memory over head for certain functions. Such as Jump non zero.
ive narrowed this down some more. in this case 2.251 is to big to fit on a 1280.
Javier and Gents,
ever since mission planner 1.0.57 i have had a problem loading the firmware unless i use arduno. Attached are my screen shots from mission planner 1.0.80 is anyone else having this issue?
Then it fails on the verify
then i can't connect? it happens on Quads planes and helicopters? any ideas
any help would be appriciated (also i can't load the latest helicopter 2.0.49 "I think" via the ardino interface it comes back with errors).
Regards,
Mark
please see here
http://www.diydrones.com/forum/topics/apm-1280-upload-problem