ESC calibration ground station

Morning everyone.

I am still waiting for my radio and wanted to test my drone via Mission planner and a Joystick and managed to calibrate the drone via Mission planned

After several crashes I noticed that the calibration is not "saved" and that every time the drone is turned on the motors will be out of sync again.

Is there any way I can rectify this while I wait for my radio?

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • Likely not as the radio typically sets the calibration on the ESC by returning the throttle to low.  Since it's waiting for a PWM signal to do this, I don't think that MP with a joystick will send this signal properly.

    • Hello Mark,

      You are right. After destroying 4 pairs of props and a GPS module I have to say that it doesn't :-)

This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile
Jun 30
Santiago Perez liked Santiago Perez's profile
Jun 21
More…