Can you please give me some tips on how you make the EZUHF work with an APM ?
Ive tried setting the EZUHF rx channel=1 to MUXED and then connecting that to input channel 1 on my APM 2.5. I then bridged #2 and #3 which is supposed to switch the APM to PPM mode. I know that my EZUHF tx is binded and talking to my rx as ive spied on the servo values using the config tool and that looks fine.
My problem is that when i spy on the channel values in MP, i can see each and every channel alternating between its true value and center. So if the throttle stick is down, i see the bar down, then centered and back to down. This goes on forever. The same is true of all other channels, they alternate between their true value and center.
My TX (Spektrum DX8) is set to 22ms DSM2.
I think that covers what ive tried.
APM=2.5, both EZUHF tx+rx=f/w 1.48(the latest one from the other day).
Replies
lol what? what are you doing on this board
Can you please give me some tips on how you make the EZUHF work with an APM ?
Ive tried setting the EZUHF rx channel=1 to MUXED and then connecting that to input channel 1 on my APM 2.5. I then bridged #2 and #3 which is supposed to switch the APM to PPM mode. I know that my EZUHF tx is binded and talking to my rx as ive spied on the servo values using the config tool and that looks fine.
My problem is that when i spy on the channel values in MP, i can see each and every channel alternating between its true value and center. So if the throttle stick is down, i see the bar down, then centered and back to down. This goes on forever. The same is true of all other channels, they alternate between their true value and center.
My TX (Spektrum DX8) is set to 22ms DSM2.
I think that covers what ive tried.
APM=2.5, both EZUHF tx+rx=f/w 1.48(the latest one from the other day).