Anyone have good pid settings for the new board. When i fly with the standard setting for APM1 the copter is not flyable. So anyone have good settings?
You need to be a member of diydrones to add comments!
This reply was deleted.
Anyone have good pid settings for the new board. When i fly with the standard setting for APM1 the copter is not flyable. So anyone have good settings?
You need to be a member of diydrones to add comments!
Replies
Ruben,
I have flown my quad ok with my APM 2.0 board, as per the settings in the attached .jpg. They have not been scientifically derived or tested. Stabilize is stable, but slightly awkward, Loiter works well enough but I am sure it can be improved. These should be good enough to get you flying on a stock 3DR frame.
Good luck, Bill
APM 2.0 PID Settings that are OK to fly.jpg
We need pid settings. Anyone?