How would I go operating a motor? Do I use actuator.controls[i] as the command? or is there another motor specific function or command?
I know I would need to first send a low pwm value to the motors, and after that I can throttle it up, so that the motors don't accidently start at full power.
Thank you once again.
Best Regards,
Israel Casillas

Views: 104

Reply to This

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service