Hey all. I'm a bit of a newbie at this game, having only played with glow fuel fixed wing RC's many years ago. All this electric stuff is doing my head in!
I purchased the ready soldered, and coded version of the Arducopter, and spent four hours putting it all together from all the pieces of conflicting instructions for different revisions all over the place. I failed to get Configurator tool to connect, but managed to run all the commands through the CLI steps successfully, and uploaded the Arducopter RC2 software.
Question is, when turn the quad on again, it does the usual beeps etc, but there is no throttle response.
In Mode 2, holding the throttle (left stick) down and to the right for several seconds does not arm the motors.
The A led shows solid green.I tested the TX/RX with servos, and it's all doing what it's meant to.
Any help would be much appreciated!