About Me:

Software engineer, hardware fiddler, funk musician.

Please tell us a bit about your UAV interest

Just playing



Activity Feed

Al Cutter replied to roger's discussion yet another motor arming frustration
"I had exactly this problem.

In the CLI I selected "Reset to Factory Defaults" to wipe the EEPROM and ran through all the relevant CLI config options again and then after rebooting back into flight mode it started working properly for me."
Apr 21, 2011
Al Cutter replied to Owen Booth's discussion I can't even arm the motors!
"I'm sorry that I don't have an answer for you, but so you know you're not alone I do have a similar problem: rx/tx are bound and most stuff seems to be working as I can run each motor separately using the four tx sticks in the motor test mode in…"
Apr 19, 2011