Any ideas for an air frame, engine, electronics,  payloads.

Views: 4888

Reply to This

Replies to This Discussion

you probilly want to go with gas or glow. and maybe a bigger airframe than most of the drones here, 80" wingspan or better with alot of surface area to cut down on fuel usage and allow a decent payload. maybe a pusher powered by a DLA 112. as for Rx/Tx if we can figure out how to connect a Xtend 900 module to an APM/oilpan setup you would have that range. i could see using one of those 98in reapers at hobyking when they come back in stock.



Try this engine, it's suitable for large scale airplanes which aircraft propellers are 22*8,22*10,23*8,23*10.

Reply to Discussion


© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service