pleas can some one tell me what is hanshake message for continue acc calibratinon to next step ?
detailed:
im sending long comand (msg 76 ) id 241 0,0,0,0,1,0,0 for start calibration routine.
then APM send me " place vehicle level and press any key" thats right ,
and then ? what i must send to tell him that its level and continue in procces ?
thx for answers ;-)
Replies
Problem solved thanks to Randy ;-) for case that someone have same problem ,
Firmware wait for meesage 77 ( command_ACK ) ;-) paramteres 241,0 works well , but probably parameters are ignored ( so you can put there what ever you want ) ;-)