Hi All,
I have problem after updated Mission Planner to new version according to massage box that shown when I run the Mission Planner. I got stuck at "Got param RC10_MAX", the error massages are show below.
Please help me on this :)
Thank you very much.
Replies
hav you had any resolve with this. I too, am just now getting this error? im not sure whats wrong.. maybe we can help each other.
You can start reading from the begining :)
I have the same problem like you posted above, except that the Got param stuck at RC10_TRIM.
I have checked voltage at I2C socket and found the voltage is 3.28 V so the problem is not with the voltage regulator.
If that's not the problem, what could be the possible problems??