Here is another project for Mavlink telemetry support. This time conversion from Mav to DuplexEx
I am going to cooperate on this with author but we are not sure how much pilots uses Duplex & Mavlink capable board. Should we publish this project ?
You need to be a member of diydrones to add comments!
Replies
Current version of project is released as open source. Check http://www.devfor8.com/mav2duplex/ for details
I hope in some basic info with first version of hex published on site during this week.
For start , here is required BOM :
- Arduino/Freeduino Mini 5V/16Mhz ATMega 328
- FTDI or other serial interface for programing Arduino
- resistor 4.7k (or something arround)
- servo connector with wires
- MavLink capable board , sending data without requests (have to be configured same way as is for MinimOSD)
jDrones-IO Board should be ok.
ad GNU GPL - yes with 90% probability but I am not sure when because I am going to //BUILD for whole next week