I'm using a MinimOSD with a Pixhawk. I had a picture w/o OSD for an hour this morning for a test.
When I unplugged the battery and plugged it back, the picture was also gone. I've been struggling for hours w/o coming any closer to a happy ending. If i connect the video cable from the camera directly to the cable for the Tx(not via MinimOSD pins), I have a picture. Is there anyway to reset to factory default or measure in any ways to figure out what's wrong?
I'v set my Fat Shark camera to PAL, and today i soldered the PAL soldering point in the back of the board w/o any luck.
I've connected all with the FTDI cable as in the picture, and the only way.
Thanks
J
Replies