I was recently given Turnigy voltage detector, but was unsure about how to install it on the apm1 board. I checked the wiki, which has a instruction for the AttoPilot sensor, which has 3 wires, while this one only have 2 (red and black).
Do I just solder the red and black wire to the same hole that the red and black wire of the attopilot sensor goes? I tried to use a multimeter to check the voltage between those two hole and got very low voltage, so I'm not sure if that is correct.
Replies
Very valuable information, it is not at all blogs that we find this, congratulations I was looking for something like that and found it here. MCDVOICE