So I just received an Iris! but when I power up the controller and the iris the Controller does not connect to the iris? how do you re bind it to the controller. I think the TX and RX are flysky.
Thank you for any help.
Michael Cook
You need to be a member of diydrones to add comments!
Replies
Please read through this --> IRIS Troubleshooting
to see if you can correct your issue.
Todd H.
What I did,
1. On the back of the RC controller there are 2 switches, I set them to on
2. Turn on the RC controller with the main button in the middle of the 2 sticks
3. Connected the battery to the IRIS
4. Close the battery case
5. Wait for like 5-10 sec
6. Push the red BLINKING button until it becomes fixed
7. Arm the motors : push LEFT-stick in the down-right corner until you hear the motor activating
8. FLY
Hope it helps,
Fabrizio.
I tried the same the iris+ always blinks in yellow. I don't know why ?