Hi
Here we go again.
Seems like there is no clear solution to this problem. I have two identicalAPM2.6 boards, and the first one is having no problems connecting to MP, but the second and newest one refuse to get "heatbeats". What I noticed is, that the good board is flashing it's LED's when it has power on, while the new board one have the Power LED turned on, so the firmware does not seems to be running. I have checked the 3.3 Volt, and the 5 Volt. And I can contact in CLI, but not do a Baro calibration.
Any good answers?
Replies
My apm board wont connect to MP and I believe its a faulty automux chip? there has been a few reports of it happening.
I am pretty sure a short in my minim osd caused it.
It cannot be the automux as I can flash the software, and verify it. I think it is a faulty ATMEGA2560 processor, where the EEPROM is good, but the processor-part is defect. Have made a dispute.