Discussions

Not connecting in flight data mode

Posted by jvmolo on November 4, 2013 at 10:56am

hello everybody

I just received a Rctimer 433 mHz kit mounted on an APM 2.

The modules are communicating, the led is solid green, I can load the settings but when I want to connect in flight data mode, it does not work, I have an error message (time out)The com port (17) is the right com port, it's not the usb (unplugged). I tried to move the com port to 5, to change the com port speed to 57600.....

And the firmware are not the same: 1.7 local and 1.6 remote ......

Any suggestion?

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

Brent November 4, 2013 at 11:51am

Connect the remote air radio to usb via FTDI and update the firmware.

http://plane.ardupilot.com/wiki/common-using-the-3dr-radio-for-tele...

This reply was deleted.

Activity

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.