Location
Gers
About
About Me:
retired, 63 years hold
Please tell us a bit about your UAV interest
It's very inresting for me, it's keep me young !!!
Hometown:
Campagne
Activity Feed
Hi everybodyI'm testing this script with an old !ixus 70.The CHDK runs perfectly, interval.bas is OK.When I run The 3DR_shoot on board, connected to the APM, with a Gentle USB2 wire, after few seconds, i have error messages. Nothing happens if it is…
Hi everybodyI'm testing this script with an old !ixus 70.The CHDK runs perfectly, interval.bas is OK.When I run The 3DR_shoot on board, connected to the APM, with a Gentle USB2 wire, after few seconds, i have error messages. Nothing happens if it is…
"The solution: reset to defaults"
"It doesn't work for me. How do you configure TCP and remote?"
"hi,
Have you found a solution?"
Have you found a solution?"
"hi,
Same after updating MP to 1.3.1. Impossible to upload waypoints, to change settings.
This is the error message.
Any solution?"
Same after updating MP to 1.3.1. Impossible to upload waypoints, to change settings.
This is the error message.
Any solution?"
"No it's impossible.
I came back from the maiden flight few . Nothing has been changed into the radio settings. The apm was disarmed."
I came back from the maiden flight few . Nothing has been changed into the radio settings. The apm was disarmed."
"no waypoints stored, it was a maiden flight for my new quad. The auto mode wasn't set up"
"I agree with you, I guess a power issue due to the ubec too weak. I changed it for a stronger"
" it's a clone (RCT).
After forcing bootloader, the led goes red
"trying in bootloader mode" following by "trying in firmware mode", sequence ATI, ATT, ATO
error message:"failed to identify radio""
After forcing bootloader, the led goes red
"trying in bootloader mode" following by "trying in firmware mode", sequence ATI, ATT, ATO
error message:"failed to identify radio""
"Sorry, they are no logs, I erased the logs trying to recover it. I don't think I accidentally armed it. I just click on connect, I faced my PC waiting for the datas."
"Unfortunately no more details. After thinking about the problem, it may be an over heating source. A new regulator failure?"
"In my opinion it's not a heating problem as it stays displayed at my home workshop and when it flies, it is in the air flow."
"Thanks Martin
- screen 2 is programmed
- no swap screen selected
- APM telemetry is enable
- both wires Y cable for using with telemetry or direct from the APM to the OSD are OK
When I plug in the battery, I see the OSD data, after a while, I only…"
- screen 2 is programmed
- no swap screen selected
- APM telemetry is enable
- both wires Y cable for using with telemetry or direct from the APM to the OSD are OK
When I plug in the battery, I see the OSD data, after a while, I only…"
":-)
It means there is no solution?"
It means there is no solution?"
