Discussions

PCB board will not pass current

Posted by Dale Brown on August 17, 2015 at 6:42pm

Ok I built a 4s3p battery using Panasonic 18650 / 3400 mah batteries. I placed a PCB board wired with one balance lead. I get current from battery side but not out P+/P-. The directions said if 0v out P+/P- then apply voltage to activate chip. I tried everything balance charger for Lipo nada "low voltage" or "connection break" shows. I tried putting other 4s battery on like jump start nada. I've changed out 3 different boards nada. Need advice please

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

Dale Brown September 4, 2015 at 11:41pm

bump. anyone?
Dale Brown August 20, 2015 at 7:37pm

Any thoughts? :)

Here is a pic don't judge it's a test after all. LOL

This reply was deleted.

Activity

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.