About

Gender

Male


Location

Summerdale, AL


Please tell us a bit about your UAV interest

Hexacopters


Hometown:

Summerdale


Activity Feed

Dale Brown commented on Jiro Hattori's blog post EMC Shielding for ArduCopter3.0
"I know this is an old post but thought it might fit 

I am currently building a Tarot 680 Pro (modified slightly). I'm getting ready to build my production one now and want to take careful consideration for shielding. Shielding only where absolutely…"
Sep 21, 2015
Dale Brown replied to Dale Brown's discussion Panasonic NCR18650B 4S3P Tarot 680 Pro - Fail
"Thanks I will look into them. I should do more research first but I just like to try. I have enough battery power now to probably power all my "other" devices. They may make for some good secondary power sources for video etc."
Sep 20, 2015
Dale Brown posted a discussion
Ok just thought I'd share my experience trying this. I built a 4S3P out of real Panasonic 18650 3400mah batteries for use on the hexa (really just to play). Well did not go so well. My two Turnigy 5000 mah managed to keep the 680 Pro up for 20…
Sep 20, 2015
Dale Brown replied to Dale Brown's discussion PCB board will not pass current
"bump. anyone?"
Sep 4, 2015
Dale Brown replied to Dale Brown's discussion PCB board will not pass current
"Any thoughts? :)

Here is a pic don't judge it's a test after all. LOL"
Aug 20, 2015
Dale Brown posted a discussion
Ok I built a 4s3p battery using Panasonic 18650 / 3400 mah batteries. I placed a PCB board wired with one balance lead. I get current from battery side but not out P+/P-. The directions said if 0v out P+/P- then apply voltage to activate chip. I…
Aug 17, 2015
Dale Brown posted a discussion
Hope this works posting from my cell.My 680 Pro is almost ready for maiden flight but one problem only 4 motors spinning. APM 2.6 3.2.1 flash, flashed with HEXA flash. Works fine if I hook each to ch 3 and spin them. Any thoughts?
May 9, 2015