Hey guys funny problem I get my new Pixhawks and load up the Mission Planner Wizard. It connects fine and goes through the musical tones just fins. Then in part three it connects and says no reason to up load firmware already on board. Then it goes to the calibration part, But it hangs up and times out. The connect on the mission planner says connected but I can NOT get past that part anymore. It did it over and over, and if I disconnect and reconnect it will time out. BUT it will connect EVERY TIME and tell me the firmware is fine. Any suggestions?
REgards
Replies
Why do you want to upload same firmware version?
Steve I dont. I want to get to the calibration step. As far as I know the only way to get to step 4 Calibration is to go through steps 1-3 no? I dont see how to get to the CALIBRATION step directly.