About

Gender

Male


Please tell us a bit about your UAV interest

I want to learn how to fly with pixhawk


Hometown:

London


Activity Feed

Steve Mitton commented on Randy's blog post ArduCopter 3.2 Released
"What kind of gimbals useable with Pixhawk?"
Nov 28, 2014
Steve Mitton replied to Shane's discussion Arducopter just not reliable.
"Same problems here, but I fight with Pixhawk.
Pixhawk is not beginner friendly."
Aug 21, 2014
Steve Mitton replied to Randy's discussion ArduCopter-3.2 beta testing
"Yes, Im a beginner. I cant use 3.1.5 because I have S.BUS problems."
Aug 15, 2014
Steve Mitton replied to Randy's discussion ArduCopter-3.2 beta testing
"This version cause stabize mode fly aways?
I do not install rc4 because stabilize fly aways."
Aug 15, 2014
Steve Mitton replied to Paul Guggenbuehl's discussion Pixhawk get stuck on part3 on the wizard. HELP!!!
"Why do you want to upload same firmware version?"
Aug 11, 2014
Steve Mitton replied to Steve Mitton's discussion Why dont working my Pixhawk?
"I found following Pixhawk websites:
http://3drobotics.com/pixhawk/http://pixhawk.org/http://www.diydron...

Because I have Pixhawk thats why ardupilot and arducopter not ok for me(this sites for Arduino based boards)."
Jun 26, 2014
Steve Mitton replied to Steve Mitton's discussion Why dont working my Pixhawk?
"I dont post because I do not have IRIS. I have DJI F550."
Jun 26, 2014
Steve Mitton replied to Steve Mitton's discussion Why dont working my Pixhawk?
"I will sell my Pixhawk and buy a Naza V2 because I cant get help for Pixhawk setup. Pixhawk not user friendly.
Sorry"
Jun 26, 2014
Steve Mitton replied to Steve Mitton's discussion Why dont working my Pixhawk?
"I cant do transmitter calibration with 3.1.5 because bars dont moveing.
I tried 3.2-rc2 and calibration sucessfull."
Jun 26, 2014
Steve Mitton replied to Steve Mitton's discussion Why dont working my Pixhawk?
"Other problem I dont find the auto mode same as in naza because auto mode means mission start.
In naza I move throttle stick center and hexa hover.  My hexa fight with air and I fight with transmitter to hold hexa in air."
Jun 25, 2014
Steve Mitton replied to Steve Mitton's discussion Why dont working my Pixhawk?
"I tried to setup autotrim but I cannot find :"Hold throttle down and rudder right for 15seconds or until you see the small red, blue and yellow leds flash in a cyclic pattern." red,blue,yellow leds. I have only a one big led and blinking green."
Jun 25, 2014
Steve Mitton replied to Steve Mitton's discussion Why dont working my Pixhawk?
"Firmware version 3.2-rc2 "
Jun 25, 2014
Steve Mitton posted a discussion
I have a little giro stabilized quad and fly very good in outdoor. And I have a hexa with Pixhawk and cannot fly. Micro quad take off easy and fly very stableHexa cannot take off or I have luck for take off but instable in air I need to heavy use tx…
Jun 24, 2014