i hope some of you can help me. :)
I have some trouble figuring out why my Pixhawk Quad not will engage auto tuning.
firmware is ArduCopter v3.2
the log shows autotune have been engaged, but the quad dont do anything in the air?
the full log is attached.
do any of you have any clue, what the problem could be?
Replies
Okay, i found a solution for this now.
it was the stick on the radio, there wasn't in center position.
i checeked my trims, and ran a radio calibration.
and now my quad is perfectly autotuned :D