Hi There,
I recently ordered 3 PX4, not knowing that the new version doesn´t have integrated servo connectors anymore (what a crap - it´s like selling a car without wheels). They came with this huge power management board, which I do not need and do n
Read more…Hi,
Im working on a autonomous drones and im using JETSON NANO and flight controller PIXHAWK .Im able to control my drone by giving rc commands on the MAVLINK terminal itself by connecting it with PIXHAWK but now i want a python code from which i can
Hi everyone! I am an undergrad mechanical engineering student who might use a pixhawk 4: https://www.banggood.com/Pixhawk-PX4...r_warehouse=CN to control four high voltage 6v-7.4v digital servos : https://hitecrcd.com/products/servos...7235mh/product
Read more…Servos not working on Pixhawk 2.4.8, Im using Flysky Transmitter and IA6B receiver, when I tried to calibrate I found none of the servos were working even after using the arming switch. But I used the same setup with APM flight controlle
Read more…Hi All
I have a question or maybe a clarification.
I been seeing everywhere,whenever RPI and Pix are connected - it is suggested to do over Telem1/2 to RPI seriial Pins or use a FTDI connector to a RPI USB.
What should happen if we connect it directly f
I have a Pixhawk FC, and am going to buy new ESCs. I was reading about calibrating and tuning ESCs and it seems that pass-through is not possible with Pixhawk([1], [2]).
(i) Are there any alternative/ solution for this? I am not going to be able to
Hey guys!
Complete and utter noob here. I am looking for a suitable ESC for the EMAX RS2205 2300kv BLDC mounted on a Martian II 220mm frame. I already have a Pixhawk PX4 2.4.7 and plan on using that. I will be using the drone for indoor videos and/ or
Read more…hi friends,
I have a strange issue with the Pixhawk 2.4.8
the Pixhawk board gets detected by the Win7 system and also by the Mission Planner when connected via the USB port.
but whenever I plug anything into the I2C port ( GPS / I2C Extender etc.) the W
I'm currently building a Tartot X6 and using Hobbywing 40A slim ESC's. They are a little too long to mount under the motor mount and I would like to place them in the carbon arm. Hobbywings website shows the same ESC placed in a carbon tube. I'm just
Read more…Hi everybody.
Several months building a large quad with pixhawk px4 fmuv2 installed, and long range video transmission, with a gimbal, and powered by a large 22volts 12000mah battery. The whole weight is 4kgs, and the quad flew for continuous 35 minut
I’m trying to get a +5v output on my Pixhawk mini, simple I thought, nope. The Holybro Pix Mini does not have any aux ports.
ALL I need is a channel either on the jumper R8 receiver or on the pix to flip between 0v and 5v when I operate a switch on my
Read more…Hello there,
I'm a 1st time drone builder and am having some troubles getting my head around all of the wiring.
Above is a picture of my schematics for the whole drone. As you can see in the bottom right, I have not yet shown the wires connecting the (
Read more…