Hi, i have recived my ardupilot hardware today.I have looked on the homepage but i can not find a instruction how to complete the construction (where to solder the gps, the usb interface the shield, servos ec.) I found a instruction how to solder the fma sensor to the board but i am not sure if i still have to do this as the shield has a connector?Is threre a kind of manual out there how to set things up?Best regards,John
You need to be a member of diydrones to add comments!
I'm trying to reorganize the site to be easier to navigate (it's hard because it has to do double duty as an active community site as well as product support) and it worries me that you weren't able to find those instructions. Could tell me a little bit more about where you expected to find them and how we can make them easier to see? (they're on the ArduPilot home page, which is a tab above and linked in the box at the top of the front page)
Replies
I'm trying to reorganize the site to be easier to navigate (it's hard because it has to do double duty as an active community site as well as product support) and it worries me that you weren't able to find those instructions. Could tell me a little bit more about where you expected to find them and how we can make them easier to see? (they're on the ArduPilot home page, which is a tab above and linked in the box at the top of the front page)
Thanks!