Gender
Male
About
Activity Feed
Hello, the following picture shows the wires of the FMA sensors as following:Ground, V+, Analog 1, Analog 0, (XY-sensor) Ground, V+, Analog 2, Unused (z-sensor)On my red shield the names are: Ground, 5V, A3, A2, A1The grounds of both sensors are…
"Maybe it has to do with the reciver, does it have to have a special Mode or so?
Mine i running at PPM18 but there are other modes like PPM24, SPCM20 and PCM20"
Mine i running at PPM18 but there are other modes like PPM24, SPCM20 and PCM20"
"in the visual gps programm (command monitor window) i get the same readings as in the serial monitor of the arduino programm it starts by saying the version of ardu pilot followed by coordinates when i switch to port 3 38400bps.
But - all the other…"
But - all the other…"
Hello, i built the plane up (a old twinstar) and everything is set up so far. (Airspeedtube, Gps, Z-Sensor, XY-Senosr, firmware loaded)The gps a Locosys LS20031 seems not to work, the leds on the gps himself just start lightning when i connect the…
"Thank you for the answers, does my connector which i made after a manual on this website a while ago have the correct order already can you tell?"
"Can nobody help me and tell me how to connect the Ir Sensors to the ArduPilot shield?"
Hello, i have the seen there is a new complete manual for the arduPilot out. I have started to build the board and shield with the old manuals, now i have made everything like in the new one.My question is where do i put the 5 pin FMA sensor cable i…
Hi, i have recived my ardupilot hardware today.I have looked on the homepage but i can not find a instruction how to complete the construction (where to solder the gps, the usb interface the shield, servos ec.) I found a instruction how to solder…
Hi, i am completly new here an i wanted a stabilized Return to launch system with gps, so i ordered the following from sparkfun:GPS-00574 Interface Cable for EM401 and EM406PRT-00743 Break Away Female Headers - Swiss Machine PinPRT-00117 Break Away…
