Support / Help
"Ardupilot 2.6 is not working with power control module only working with USB cable via laptop"
Hello to all!
Given that we are beginners.
We made our first quadricopter model
based on Ardupilot 2.6 with external gps, 4 motors and a power control unit with a radio control and a receiver.
We first installed the appropriate firmware using Mission Planner latest version via automatic update (we did the same with the other Apm software firmware programming AMP2.6 )
We made the test and the tuning of the radio command and carried out the test of gps
Unfortunately, as we disconnect the USB cable and connect the 3DR Power Module called power control link
common-Measuring battery voltage and current consumption with APM | ArduCopter
with 4'th ESC. The Ardupilot APM 2.6 "DO NOT TURN ON and not' sign of life" - Unfortunately, it only works with the USB cable.
We are completely disheartened we also reset the software with the reset button (assuming we're not sure if the reset was complete, and the same was done in mode 'CLI / Terminal client said)
Do you have any suggestions?
In addition, with the USB cable connected VIA Laptop, we measured a voltage of 4.7 Volts DC area and you turn around regularly and verify all voltage calibration optimal power control with a battery LIPO 4S perfectly connected.
Thank you in advance for the whole community scusandici have written perhaps too
Anyone knows how to give us some tips to solve our problem? Is there anyone who can help us step by step and follow us, we are really confused. Thanks again to all of the community diydrones.com ....;) sorry for ours terrible English ...