Power cycling APM2.5 returns to default

I have a problem when upgrading to the new 2.9 firmware.


When changing Stab_P to 0 for tuning.
After power cycling the APM it will load the default Stab_P = 4,5.


Have tried reflashed firmware on the APM 2.5, erased EEPROM but nothing.

Any thoughts on this ?

Best regards

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • This picture below shows the values it takes when I have done a "erase" from the cli.

    3692601813?profile=originalAnd when changing stab_p to 0 and pressing "Write Params" and then "Refresh Params" it takes the new values no problem.

    3692601740?profile=originalBut after disconnecting the USB to APM and connecting it again it takes the values from the first picture.

This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile
Jun 30
Santiago Perez liked Santiago Perez's profile
Jun 21
More…